BowFishing Country banner

1 - 10 of 10 Posts

·
Registered
Joined
·
98 Posts
Discussion Starter #1
So I went out on the river to play in the airboat yesterday... got to having to much fun and slid aroung and hit a stump. Now I have a nice little dent in the side. What is the best way get it out? Its not creased or anything.
 

·
Chainsaw Willy
Joined
·
12,026 Posts
A long high lift Jack...use boards to brace it up...its really easy...just brace it up on the other side and Jack that sucker out.
 

·
Registered
Joined
·
526 Posts
wish i had an airboat to dent up.....where did you put in scarb?
 

·
Chainsaw Willy
Joined
·
12,026 Posts
Swede Johnson SRA #1
aint no fish up there...Depending on where the dent is , I bet your gona have to pull your motor and stand…don’t go hitting it with a big old hammer…that ill remove the dent but it will put several little dents where the hammer hit… like get a 2X6 2’ long and place it on the dent …put the foot of the highlift jack on that 2X6 get a good solid stick of lumber “4x4” that runs the width of the boat and put it on the lip of the jack and put you a another solid piece of lumber on the opposite side of the boat “like a 6’ 4X4” jack it out..do u know what im sayin???
 

·
Registered
Joined
·
2,605 Posts
what brady said should work, mabye...
 

·
Chainsaw Willy
Joined
·
12,026 Posts
I know it will work! I just did it on my Diamondback..both sides had dents in the back of the boat form side swiping stumps all the time…you are gona swear ur boat is fixing to explode when u bow up on that jack but it works! I wish yall could have seen what I did to get the dents out of the floor under my deck! Good lord…I should of got someone to video that chit.
 
1 - 10 of 10 Posts
Top