How can i remove the metal tip holder that is glued onto the arrow shaft so that i cant change to a differant style?
How to you remove tip?
Iacarper
1 - 7 of 7 Posts
Joined
·
801 Posts
You can heat it up and then take pliers and pull it off or you can cut your arrow. an inch or two wont hurt your arrow at all. there is probably other ways but i heat mine and pull em off.
Joined
·
941 Posts
pretty much I put my arrow head in a vice when heating while pulling at the same time usually pops right off
Joined
·
553 Posts
what would you do if they were crimped on there would ya just cut it off instead
Joined
·
1,193 Posts
If it's crimped you may have to cut the shaft and drill out the tip.
Joined
·
1,554 Posts
I would highly recommend just cutting them off, you only loose about 3/4in of shaft material and use a high speed cutoff saw or abrasive type saw to cut fiberglass with. Fiberglass does not do good with heat and very fine line between hot and too hot and you would end up with a feathered shaft.
Joined
·
5,255 Posts
X2 Better off just cutting the tip off if you plan to use the arrow again because heat will only make it weaker.
1 - 7 of 7 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
