BowFishing Country banner
1 - 5 of 5 Posts

·
Registered
Joined
·
175 Posts
Discussion Starter · #1 ·
I recently had an LVX that was a gift sent off for a "GNAT" conversion. Like most folks I was very disappointed with the draw cycle on the original factory setup. It is smooth as butter now and I
Wood Plant Grass Terrestrial plant Twig

finally got the setup I have been looking for. It is my "Oneida Gnat".
 

·
Registered
Joined
·
175 Posts
Discussion Starter · #3 ·
Just new cables, yokes, slider and string?
yep. It saves about $150 to reuse the original limbs instead of using there's. I always liked the original look anyway and I figure Oneida probably has learned how to make pretty good limbs by now anyway. When it was all said and done if I had paid for the original bow and upgrades it was about $150-200 cheaper than a complete GNAT.
 

·
Registered
Joined
·
2,190 Posts
So the misconception here is that those limbs are made by Oneida. They are in fact not. The reason it says "Powered by Oneida" or "Oneida" on the limbs is because muzzy is using their paten for their power limbs. I have seen a lot of these power limbs snap and the outboards super warped. I truly hope that isnt the case here
 
1 - 5 of 5 Posts
Top