I hav an outboard jet on a jackplate. I have built 3 different spray plates fir the back of the boat to stop the spray.. I can't get it right! The one I have on there now is 12" wide and goes over the intake foot when the motor is trimmed down all the way. Sprays out both sides! If I trim it up at all it sprays 6 ft in the air!! What can I do?
Outboard jetdrive issues!! Help me
SOOG
1 - 1 of 11 Posts
Joined
·
730 Posts
I have limted experince with Jet drives. When I was poking around on the net looking I saw some spary plates that are somewhat cupped so the foot fits into the cupped part? Not sure if that would help or not...You may be better off asking your question on another site. I would have to think there is a jet drive forum out there somewhere?
1 - 1 of 11 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
