BowFishing Country banner

1 - 14 of 14 Posts

·
Registered
Joined
·
785 Posts
Discussion Starter · #1 ·
I need to know where to get some polymer for a fan boat. What kind and is it the same stuff they use in dump truck beds.
 

·
Registered
Joined
·
7,721 Posts
PM Garquest on here. He can give the info on some he just had his boat done!
 

·
Registered
Joined
·
542 Posts
i would contact Ty Fulmer, chevyscoot...he can probably help you out.
 
G

·
I think most would agree 1/4” is the way to go on a fan rig, that chit is heavy
yes, thats all you will need. As long as you dont hit anything at speed with your outboard, 1/4'' will last plenty long enough, the standard grade black will also be all you need too. Tooling along at fan speeds wont do too much damage to the poly, plus you probably wont be running too much dry ground either. LOL
 

·
Registered
Joined
·
486 Posts
I have it on my 1860 gator-tail....pounded it off rocks and logs and mud for a while now....no problem!
 

·
Registered
Joined
·
540 Posts
I will 2nd horn plastics...http://www.superslide.com/ I would not go less than 1/4" just to give the screws something to hold.

Really should give it a lot of thought to see if the weight gains will reaelly be work it. I havent seen a fanboat than can run dry yet.
 

·
Registered
Joined
·
36 Posts
How much would it cost to put down polymer on a 1760 fan boat?
 

·
Registered
Joined
·
36 Posts
That is not to bad.
I think With some help of a few buddies I believe I could get it done in a few days
 
1 - 14 of 14 Posts
Top