BowFishing Country banner

She's Home!!! Plenty of pics.

4K views 46 replies 31 participants last post by  ILLINOIS BOWHUNTER 
#1 ·
Here are the specifics -

Hull 2072 Vcrimped Bottom (25" transom,2" washout plug)
30" sides
10” walkarounds
Fuel Cell
Rear Bench Seat
2’ extended rear deck
6’ front deck with light rail
Digital Ballast Rack Under Bow
Bow Boxes near front deck
Center Console with seat in front
Sharkeye Navigation Lights
Complete Fan Set Up ( Stand with steer/throttle cables, steer stick, bearings, shafts, and accessories)
Shroud (welded aluminum)
Fan Motor mounted and wired
Custom Tandem Axle Trailer
Kohler 40 HP fan motor
1.69:1 Reduction
59" 3 blade Ultraprop

150 Mercury Optimax
 

Attachments

See less See more
4
#9 ·
Looks good. Why are the float pods up high and not flush with the sides and bottom of the boat?

Also could you take a picture of the fanstand?
 
#28 ·
It's just the ring Around that's solid the rest is open. It won't affect the performance or noise levels. They've done them before and you can't tell a difference. A completely closed off shroud would not work however
 
#30 ·
not to hijack....... but I'm gonna :D

The myth busters tested a hover fan and a fan with tight tolerances to a solid sidewall created more thrust than one where the tolerances weren't as tight on the sides(fan tips) I guess it didn't allow as much air to be pushed off to the sides.

I could see where it might be a bit louder though since it should be making a little bit more thrust
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top