I Used 1" shed 40 and a pipe bender from harbor freight on this last one. I fit a piece of 3/4" inside of it for the top piece for the handle and went from there. The pipe bender doesn't bend all that good without denting the tube slightly and if I went much more it would prolly try and flatten. But it worked out.
I just cut the pivot point off and rebuilt it. When I did I went longer than it was .. The longer it is the shorter the throw on the still will be. I leave it as long as I can under my deck
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to bowfishers, anglers and enthusiasts. Come join the discussion about safety, gear, boats, bows, tackle, reviews, accessories, classifieds, and more!