BowFishing Country banner
1 - 7 of 7 Posts

·
Registered
Joined
·
1,161 Posts
BowfishingExtreme has about all of the troller parts that you'll need.

The one troller that I helped extend wears a shaft that BeanPole got at BackwaterBowfishing.
 

·
Registered
Joined
·
1,154 Posts
Discussion Starter · #4 ·
I see the shafts what all do you need to change the shaft out? Just the shaft or do you need anything extra?
 

·
Registered
Joined
·
317 Posts
i got a 96" one last year.....just have to extend your wires and make sure all the old threading glue is out of the motor part where the pole threads in. i put a little silicone around after i threaded it in just to be sure no water gets in.
 

·
Registered
Joined
·
1,161 Posts
The wires will obviously need extended. Make sure you get a good splice and offset them from each other so they take up less space and do not rub each other. Heat Shrink is a good thing.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top